ATTINY24A-MUR 8-Bit AVR Microcontroller with 2KB Flash 12MHz Speed 128B EEPROM 12 I/O Pins 1.8V-5.5V Operation -40°C to +85°C and Ultra-Low Power for

ATTINY24A-MUR 8-Bit AVR Microcontroller with 2KB Flash 12MHz Speed 128B EEPROM 12 I/O Pins 1.8V-5.5V Operation -40anddeg;C to +85anddeg;C andamp; Ultra-Low Power for Compact Designs

andnbsp;

Features

andbull; High Performance, Low Power AVRandreg; 8-bit Microcontroller

andbull; Advanced RISC Architecture

andnbsp; andndash; 120 Powerful Instructions

andnbsp; andndash; Most Single Clock Cycle Execution

andnbsp; andndash; 32 x 8 General Purpose Working Registers

andnbsp; andndash; Fully Static Operation

andbull; High Endurance, Non-volatile Memory Segments

andnbsp; andndash; 2K/4K/8K Bytes of In-System, Self-programmable Flash Program Memory

andbull; Endurance: 10,000 Write/Erase Cycles

andnbsp; andndash; 128/256/512 Bytes of In-System Programmable EEPROM

andbull; Endurance: 100,000 Write/Erase Cycles

andnbsp; andndash; 128/256/512 Bytes of Internal SRAM

andnbsp; andndash; Data Retention: 20 years at 85anddeg;C / 100 years at 25anddeg;C

andnbsp; andndash; Programming Lock for Self-programming Flash andamp; EEPROM Data Security

andbull; Peripheral Features

andndash; One 8-bit and One 16-bit Timer/Counter with Two PWM Channels, Each

andnbsp; andndash; 10-bit ADC

andbull; 8 Single-ended Channels

andbull; 12 Differential ADC Channel Pairs with Programmable Gain (1x / 20x)

andnbsp; andndash; Programmable Watchdog Timer with Separate On-chip Oscillator

andnbsp; andndash; On-chip Analog Comparator

andnbsp; andndash; Universal Serial Interface

andbull; Special Microcontroller Features

andnbsp; andndash; debugWIRE On-chip Debug System

andnbsp; andndash; In-System Programmable via SPI Port

andnbsp; andndash; Internal and External Interrupt Sources

andnbsp; andnbsp; andbull; Pin Change Interrupt on 12 Pins

andnbsp; andndash; Low Power Idle, ADC Noise Reduction, Standby and Power-down Modes

andnbsp; andndash; Enhanced Power-on Reset Circuit

andnbsp; andndash; Programmable Brown-out Detection Circuit with Software Disable Function

andnbsp; andndash; Internal Calibrated Oscillator

andnbsp; andndash; On-chip Temperature Sensor

andbull; I/O and Packages

andnbsp; andndash; Available in 20-pin QFN/MLF/VQFN, 14-pin SOIC, 14-pin PDIP and 15-ball UFBGA

andnbsp; andndash; Twelve Programmable I/O Lines

andbull; Operating Voltage:

andnbsp; andndash; 1.8andnbsp; andndash; 5.5V

andbull; Speed Grade:

andnbsp; andndash; 0 andndash; 4 MHz @ 1.8 andndash; 5.5V

andnbsp; andndash; 0 andndash; 10 MHz @ 2.7 andndash; 5.5V

andnbsp; andndash; 0 andndash; 20 MHz @ 4.5 andndash; 5.5V

andbull; Industrial Temperature Range: -40anddeg;C to +85anddeg;C

andbull; Low Power Consumption

andnbsp; andndash; Active Mode:

andnbsp; andnbsp; andbull; 210 andmicro;A at 1.8V and 1 MHz

andnbsp; andndash; Idle Mode:

andnbsp; andnbsp; andbull; 33 andmicro;A at 1.8V and 1 MHz

andnbsp; andndash; Power-down Mode:

andnbsp; andnbsp; andbull; 0.1 andmicro;A at 1.8V and 25anddeg;C

andnbsp;

Applications

1. Consumer Electronics andamp; Smart Home

• Remote controls, keyboards, LED controllers

• Small household appliances (e.g., coffee makers, fans)

• Smart sensor nodes (temperature/humidity monitoring)

2. Industrial Control andamp; Automation

• Small motor control (stepper/DC motor PWM driving)

• Industrial sensor signal acquisition and processing

• Low-complexity PLC or HMI interface control

3. IoT andamp; Wireless Devices

• Battery-powered wireless sensors (Zigbee/Bluetooth module auxiliary control)

• Low-power data loggers (using EEPROM for storage)

4. Automotive Electronics andamp; Peripherals

• In-car accessories (LED ambient lighting control, simple switch detection)

• Aftermarket automotive electronics (OBD adapter support MCU)

5. Portable andamp; Battery-Powered Devices

• Electronic toys, small handheld devices

• Solar/Wi-Fi sensor nodes (utilizing 1.8V ultra-low voltage support)

Descriptions

Port B is a 4-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The Port B output buffers have symmetrical drive characteristics with both high sink and source capability except PB3 which has the RESET capability. To use pin PB3 as an I/O pin, instead of RESET pin, program (andlsquo;0andrsquo;) RSTDISBL fuse. As inputs, Port B pins that are externally pulled low will source current if the pull-up resistors are activated. The Port B pins are tri-stated when a reset condition becomes active, even if the clock is not running.

Reset input. A low level on this pin for longer than the minimum pulse length will generate a reset, even if the clock is not running and provided the reset pin has not been disabled. The min imum pulse length is given in Table 20-4 on page 176. Shorter pulses are not guaranteed to generate a reset.

Port A is a 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The Port A output buffers have symmetrical drive characteristics with both high sink and source capability. As inputs, Port A pins that are externally pulled low will source current if the pull-up resistors are activated. The Port A pins are tri-stated when a reset condition becomes active, even if the clock is not running.

andnbsp;

INFORMATION

Category	Integrated Circuits (ICs) Embedded Microcontrollers	andnbsp;
Mfr	Microchip Technology	andnbsp;
Series	AVRandreg; ATtiny	andnbsp;
Packaging	Tape andamp; Reel (TR) Cut Tape (CT) Digi-Reelandreg;	andnbsp; andnbsp; andnbsp;
Part Status	Active	andnbsp;
DigiKey Programmable	Verified	andnbsp;
Core Processor	AVR	andnbsp;
Core Size	8-Bit	andnbsp;
Speed	20MHz	andnbsp;
Connectivity	USI	andnbsp;
Peripherals	Brown-out Detect/Reset, POR, PWM, Temp Sensor, WDT	andnbsp;
Number of I/O	12	andnbsp;
Program Memory Size	2KB (1K x 16)	andnbsp;
Program Memory Type	FLASH	andnbsp;
EEPROM Size	128 x 8	andnbsp;
RAM Size	128 x 8	andnbsp;
Voltage - Supply (Vcc/Vdd)	1.8V ~ 5.5V	andnbsp;
Data Converters	A/D 8x10b	andnbsp;
Oscillator Type	Internal	andnbsp;
Operating Temperature	-40anddeg;C ~ 85anddeg;C (TA)	andnbsp;
Mounting Type	Surface Mount	andnbsp;
Supplier Device Package	20-QFN-EP (4x4)	andnbsp;
Package / Case	20-WFQFN Exposed Pad	andnbsp;
Base Product Number	ATTINY24

andnbsp;

Drawing

andnbsp;

Our advantage :

• High quality products --- our offers are 100% new and original, ROHS
• Competitive price --- good Purchase channels with good price.
• Professional service --- strict quality testing before the shipment, and perfect after-sales service after the purchase.
• Adequate inventory --- With the support of our strong Purchasing team,
• Fast delivery --- we will ship the goods within 1-3 working days after the payment confirmed.

andnbsp;

be sure to meet your need for all kinds of components. ^_^


Product List
Supply a Series of Electronic Components, full range of semiconductors, active andamp; passive Components.We can help you to get all for bom of the PCB,IN a word, you can get one-stop solution here,


The offers including:
Integrated Circuit, Memory ICs, Diode, Transistor , Capacitor, Resistor, Varistor, Fuse, Trimmer andamp; Potentiometer, Transformer, Battery, Cable, Relay, Switch, Connector, Terminal Block, Crystal andamp; Oscillator, Inductor, Sensor, Transformer, IGBT Driver, LED,LCD, Convertor, PCB (Printed Circuit Board),PCBA (PCB Assembly)

Strong in Brand:
Microchip, MAX, AD, TI, ATMEL, ST, ON, NS, Intersil, Winbond, Vishay, ISSI, Infineon, NEC, FAIRCHILD, OMRON,YAGEO, TDK, etc

Product Tags:

ATTINY24A-MUR 8-bit AVR microcontroller

      

low power AVR microcontroller 12MHz

      

compact AVR microcontroller 12 I/O pins

      

ATTINY24A-MUR 8-Bit AVR Microcontroller with 2KB Flash 12MHz Speed 128B EEPROM 12 I/O Pins 1.8V-5.5V Operation -40°C to +85°C and Ultra-Low Power for Images